RGBKB Build Guides
  • RGBKB build guides
  • Mün 2
    • Overview
    • Assembly
    • Accessories
  • Phobos
    • Introduction
    • Flashing
    • Assembly - Switchplate
    • Assembly - Plateless
    • Accessories
  • Zygomorph 3 (WIP)
    • Introduction (WIP)
  • Sol 3
    • Introduction
    • Flashing
    • Assembly
    • Accessories
    • Fullhand
  • Mün
    • Introduction
    • Flashing
    • Assembly
  • Zygomorph 2 (EOL)
    • Introduction
  • Pan
    • Introduction
    • Soldering
    • Flashing
    • Assembly
  • Sol 2 build guide
    • Introduction
    • Flashing
    • Assembly
    • Sol Power
    • Default Keymap
  • Zygomorph Build Guide
    • Introduction
    • Assembly
    • Flashing
  • Zen2 Build Guide
    • Introduction
    • Assembly
    • Flashing
  • Archive
    • USB-Fusion
    • Sol 1 Build guide
Powered by GitBook
On this page
  • Tenting feet:
  • MKi2c modules:
  1. Phobos

Accessories

PreviousAssembly - PlatelessNextIntroduction (WIP)

Last updated 2 years ago

Tenting feet:

MKi2c modules:

Modules should be installed after the switchplate & switches have been installed onto the PCB & case middle. Orient the module so that the springpins contact the pads on top of the PCB. Use the included screws to secure the module to the PCB.

Some OLED modules may have long pins connecting the OLED panel to the carrier board. These pins may contact metal switchplates, and can be cut down with flush cutters.

18 degree configuration
10 degree configuration